No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - IP Service

S1720, S2700, S5700, and S6720 V200R012(C00 and C20)

This document describes the configurations of IP Service, including IP address, ARP, DHCP, DHCP policy VLAN, DNS, mDNS gateway, mDNS relay, UDP Helper, IP performance optimization, IPv6, DHCPv6, IPv6 DNS, IPv6 over IPv4 tunnel, and IPv4 over IPv6 tunnel.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
(Optional) Configuring Attributes for a BOOTP Client

(Optional) Configuring Attributes for a BOOTP Client

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run interface interface-type interface-number [.subinterface-number ]

    The interface view or sub-interface view is displayed.

    NOTE:

    Only the S5720EI, S5720HI, S5730HI, S6720EI, S6720HI, and S6720S-EI support sub-interfaces.

  3. (Optional) On an Ethernet interface, run undo portswitch

    The interface is switched to Layer 3 mode.

    By default, an Ethernet interface works in Layer 2 mode.
    NOTE:

    Only the S5720EI, S5720HI, S5730HI, S6720EI, S6720HI, and S6720S-EI support switching between Layer 2 and Layer 3 modes.

  4. Run dhcp client hostname hostname

    A host name is configured for the BOOTP client.

    By default, no host name is configured for a BOOTP client.

    A host name allows access to a BOOTP client through a domain name. A domain name consists of a host name and domain name suffix.

  5. Run dhcp client client-id client-id

    An identifier is configured for the BOOTP client.

    By default, a client's MAC address is used as its identifier.

Translation
Download
Updated: 2018-12-24

Document ID: EDOC1100038342

Views: 86222

Downloads: 283

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next