No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - IP Service

S1720, S2700, S5700, and S6720 V200R012(C00 and C20)

This document describes the configurations of IP Service, including IP address, ARP, DHCP, DHCP policy VLAN, DNS, mDNS gateway, mDNS relay, UDP Helper, IP performance optimization, IPv6, DHCPv6, IPv6 DNS, IPv6 over IPv4 tunnel, and IPv4 over IPv6 tunnel.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Overview of IP Performance Optimization

Overview of IP Performance Optimization

A large number of packets need to be forwarded on the network, which may cause network congestion and degrade network performance. IP performance optimization can solve the problem. You can adjust parameters or forwarding modes for IP packets to achieve optimal network performance.

IP performance can be optimized using any of the following functions:

  • Configuring source IP addresses verification
  • Configuring the switch to fragment outgoing IP packets
  • Configuring a load balancing mode for IP packet forwarding
  • Configuring layer 3 hardware forwarding of IPv4 packets
  • Configuring the switch to discard IP packets with options
  • Configuring the switch to discard IP packets with expired TTL
  • Configuring the switch to discard IP packets matching no routing entry
  • Configuring the switch to discard IPv6 packets with specified extension headers
  • Configuring an interface to forward directed broadcast packets
  • Disabling the IP packet checking function
  • Enabling the switch to perform layer 2 forwarding for IP traffic during a ring network switchover
  • Configuring ICMP properties
  • Configuring TCP properties
Translation
Download
Updated: 2018-12-24

Document ID: EDOC1100038342

Views: 86019

Downloads: 283

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next