No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - IP Service

S1720, S2700, S5700, and S6720 V200R012(C00 and C20)

This document describes the configurations of IP Service, including IP address, ARP, DHCP, DHCP policy VLAN, DNS, mDNS gateway, mDNS relay, UDP Helper, IP performance optimization, IPv6, DHCPv6, IPv6 DNS, IPv6 over IPv4 tunnel, and IPv4 over IPv6 tunnel.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
(Optional) Forcing a DHCP Server to Reply with a DHCP NAK Message

(Optional) Forcing a DHCP Server to Reply with a DHCP NAK Message

Context

When a DHCP client goes online in two steps, the IP address requested by the DHCP client is in the IP address pool, but no lease record of the DHCP client is found in the address pool. For example, after obtaining an IP address from another DHCP server, a wireless user roams to the current DHCP server and the original IP address is in the address pool of the current DHCP server. Alternatively, the address pool is reset and the original user needs to go online again. In this case, when receiving a DHCP Request message from the DHCP client, the DHCP server keeps silent and does not reply the DHCP client with a DHCP NAK message. The DHCP client can apply for an IP address to go online again in four steps only after the two steps for the client to go online time out. As a result, the DHCP client is slow in obtaining an IP address. To force the DHCP server to reply with a DHCP NAK message, you can run the dhcp server force response command, so that the DHCP client can quickly enter the four-step process for going online and apply for an IP address again.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run dhcp server force response

    The DHCP server is forced to reply with a DHCP NAK message.

    By default, a DHCP server is not forced to reply with a DHCP NAK message.

Translation
Download
Updated: 2018-12-24

Document ID: EDOC1100038342

Views: 91096

Downloads: 292

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next