No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Configuration Guide - WLAN-AC

S5700 and S6720 V200R012C00

This document describes the configurations of WLAN, including WLAN Service Configuration, Radio Resource Management, Roaming, WLAN QoS, WLAN Security, WDS, Mesh, Location, Hotspot 2.0, Dual-Link Cold Backup, N+1 Backup.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Implementation Precautions for the Healthcare IoT Solution

Implementation Precautions for the Healthcare IoT Solution

Software and Hardware Installation Precautions

RFID receivers are embedded in the APs as built-in cards, or connected to the APs through USB ports as external USB modules.

Only the AP2050DN, AP2050DN-E, AP2050DN-S, AP2051DN, AP2051DN-E, AP2051DN-S, AP4030TN, AP4050DN-E, AP4051DN, AP4051DN-S, AP4051TN, AP4151DN, AP5050DN-S, AP6050DN, AP6052DN, AP6150DN, AP7050DE, AP7050DN-E, AP7052DE, AP7052DN, AP7152DN, R250D-E, and R251D-E can be used.

Among them, the AP4050DN-E, AP7052DN, and AP7152DN can connect to RFID receivers through card slots or USB ports, while the other APs can connect to RFID receivers only through USB ports.

Service Planning Precautions

In infant abduction prevention and infusion management scenarios, only Layer 2 and Layer 3 networking architectures are supported, and NAT traversal is not supported.

Configuration Precautions

When Enjoyor IoT cards are used, it is recommended that static IP addresses be configured for APs. This is because IP addresses of IoT cards are added on Enjoyor servers and IoT cards use AP IP addresses for communication. If AP IP addresses are dynamically allocated through DHCP, AP IP addresses that dynamically change may be inconsistent with those added on Enjoyor servers.

Updated: 2018-12-24

Document ID: EDOC1100038361

Views: 158840

Downloads: 436

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next