No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - WLAN-AC

S5700 and S6720 V200R012C00

This document describes the configurations of WLAN, including WLAN Service Configuration, Radio Resource Management, Roaming, WLAN QoS, WLAN Security, WDS, Mesh, Location, Hotspot 2.0, Dual-Link Cold Backup, N+1 Backup.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring an AP to Report Information About Its LLDP Neighbors

Configuring an AP to Report Information About Its LLDP Neighbors

Context

After the AP discovers a neighbor, the AP sends neighbor information to the AC. The NMS then obtains AP's LLDP information from the AC to learn the network topology.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run wlan

    The WLAN view is displayed.

  3. Run ap-system-profile name profile-name

    An AP system profile is created, and the AP system profile view is displayed.

    By default, the system provides the AP system profile default.

  4. Run lldp report enable

    The AP is enabled to report information about its LLDP neighbors.

    By default, an AP does not report information about its LLDP neighbors.

  5. (Optional) Run lldp report-interval interval-time

    The interval at which the AP reports neighbor information to an AC is configured.

    By default, an AP reports LLDP neighbor information to an AC at an interval of 30 seconds.

  6. Run quit

    Return to the WLAN view.

  7. Bind an AP system profile to an AP group or AP.

    • Binding an AP system profile to an AP group.
      1. Run the ap-group name group-name command to enter the AP group view.
      2. Run the ap-system-profile profile-name command to bind the AP system profile to the AP group.

        By default, the AP system profile default is bound to an AP group.

    • Binding an AP system profile to an AP.
      1. Run the ap-id ap-id, ap-mac ap-mac, or ap-name ap-name command to enter the AP view.
      2. Run the ap-system-profile profile-name command to bind the AP system profile to the AP.

        By default, no AP system profile is bound to an AP.

Translation
Download
Updated: 2018-12-24

Document ID: EDOC1100038361

Views: 148723

Downloads: 425

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next