No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Configuration Guide - WLAN-AC

S5700 and S6720 V200R012C00

This document describes the configurations of WLAN, including WLAN Service Configuration, Radio Resource Management, Roaming, WLAN QoS, WLAN Security, WDS, Mesh, Location, Hotspot 2.0, Dual-Link Cold Backup, N+1 Backup.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Rogue Device Detection and Containment

Rogue Device Detection and Containment

In Figure 10-5, an employee connects to a rogue fat AP from the campus network or uses simulation software to simulate a fat AP and deceive users into connecting to the corresponding SSID. After WIDS and WIPS are configured, the AC identifies the rogue AP. The monitor AP then uses the rogue AP's identity information to broadcast a Deauthentication frame. After STAs associating with the rogue AP receive the Deauthentication frame, they disassociate from the rogue AP. This countermeasure prevents STAs from associating with the rogue AP.

Figure 10-5  Configuring WIDS and WIPS against devices

Updated: 2018-12-24

Document ID: EDOC1100038361

Views: 158841

Downloads: 436

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next