No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - WLAN-AC

S5700 and S6720 V200R012C00

This document describes the configurations of WLAN, including WLAN Service Configuration, Radio Resource Management, Roaming, WLAN QoS, WLAN Security, WDS, Mesh, Location, Hotspot 2.0, Dual-Link Cold Backup, N+1 Backup.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Application of Dual-Link Cold Backup

Application of Dual-Link Cold Backup

1+1 Dual-Link Cold Backup

In the AC+FIT AP network architecture, the AC manages and controls WLAN services for wireless users in a centralized manner. One AC usually controls hundreds of APs and over ten thousand STAs. When a fault occurs on the AC or the link between the AC and AP fails, the services of all users connected to the AC are interrupted. If dual-link cold backup is enabled, the standby AC controls the WLAN services for wireless users when a fault occurs on the active AC or the link between the active AC and AP fails. This reduces service interruption time.

As shown in Figure 21-2, AC1 and AC2 provide dual links for STAs. AC1 is the active device, serving AP1 and AP2. AC2 is the standby device. Each AP sets up a CAPWAP tunnel with AC1 and AC2 respectively. When the APs detect that AC1 fails, the CAPWAP tunnels between APs and AC2 become the active tunnels, and AC2 becomes the active AC. After AC1 recovers, it becomes the active AC or still functions as the standby AC depending on the configuration.

Figure 21-2  1+1 dual-link cold backup networking diagram

Translation
Download
Updated: 2018-12-24

Document ID: EDOC1100038361

Views: 158427

Downloads: 436

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next