No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - WLAN-AC

S5700 and S6720 V200R012C00

This document describes the configurations of WLAN, including WLAN Service Configuration, Radio Resource Management, Roaming, WLAN QoS, WLAN Security, WDS, Mesh, Location, Hotspot 2.0, Dual-Link Cold Backup, N+1 Backup.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring APs to Communicate with the Host Computer

Configuring APs to Communicate with the Host Computer

Context

After receiving information reported by student wristbands, RFID cards sends the information to the host computer through APs and upstream Ethernet links. To enable the RFID cards to connect to the correct host computer and establish links, configure communication parameters between the APs and host computer.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run wlan

    The WLAN view is displayed.

  3. Run iot-profile name profile-name

    An IoT profile is created and the IoT profile view is displayed.

    By default, no IoT profile is created.

  4. Run type common

    The IoT card type is set to common.

    The default type of an IoT card is common.

  5. Run management-server { domain domain-name | server-ip server-ip } server-port server-port-num

    The IP address and port number of a host computer is configured.

    By default, no host computer is configured.

  6. (Optional) Run share-key key-value

    A shared key is configured.

    By default, no shared key is configured.

  7. Run quit

    Return to the WLAN view.

  8. Apply configurations to an IoT card interface.

    • Bind the IoT profile in the IoT card interface view of an AP group.
      1. Run the ap-group name group-name command to enter the AP group view.
      2. Run the card card-number command to enter the IoT card interface view.
      3. Run the iot-profile profile-name config-agent tcp-port tcp-port command to bind the IoT profile and configure the local port number mapping the IoT card interface.

        By default, no IoT profile is bound to an IoT card interface.

        NOTE:

        Telpo's host computer can connect to APs using TCP.

    • Bind the IoT profile in the IoT card interface view of an AP.
      1. Run the ap-id ap-id, ap-mac ap-mac, or ap-name ap-name command to enter the AP view.
      2. Run the card card-number command to enter the IoT card interface view.
      3. Run the iot-profile profile-name config-agent tcp-port tcp-port command to bind the IoT profile and configure the local port number mapping the IoT card interface.

        By default, no IoT profile is bound to an IoT card interface.

        NOTE:

        Telpo's host computer can connect to APs using TCP.

Verifying the Configuration

  • Run the display iot-profile { name profile-name | all } command to check the IoT profile configuration.
  • Run the display reference iot-profile name profile-name command to check reference information about the IoT profile.
Translation
Download
Updated: 2018-12-24

Document ID: EDOC1100038361

Views: 157920

Downloads: 436

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next