No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - WLAN-AC

S5700 and S6720 V200R012C00

This document describes the configurations of WLAN, including WLAN Service Configuration, Radio Resource Management, Roaming, WLAN QoS, WLAN Security, WDS, Mesh, Location, Hotspot 2.0, Dual-Link Cold Backup, N+1 Backup.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring a Hotspot 2.0 Profile

Configuring a Hotspot 2.0 Profile

Context

Hotspot 2.0 networks are usually provided by network service providers who can set network parameters in compliance with Hotspot 2.0 standards to identify the networks. Wireless terminals can obtain network information and automatically select and access the desired networks based on the preset identity credentials. The administrator needs to configure the APs through Hotspot 2.0 profiles according to the parameters provided by the network service providers so that the APs can provide Hotspot 2.0 network information to the wireless terminals. After the Hotspot 2.0 profiles are applied to VAP profiles, the configuration takes effect.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run wlan

    The WLAN view is displayed.

  3. Run hotspot2-profile name profile-name

    A Hotspot 2.0 profile is created and the Hotspot 2.0 profile view is displayed.

    By default, no Hotspot2.0 profile is available.

  4. Run network-type { emergency-service | personal-device | private | private-guest | public-chargeable | public-free | test | wildcard } [ internet-access ]

    The Hotspot 2.0 network type and Internet access status are configured.

    By default, the network type is set to wildcard, and Internet access is not supported.

  5. (Optional) Run hessid mac-address

    HESSID of the Hotspot 2.0 network is configured.

    By default, no HESSID is configured.

  6. (Optional) Run venue-type group-code venue-group type-code type-code-value

    The venue type of the Hotspot 2.0 network is configured.

    By default, no venue type information is configured for a Hotspot2.0 network.

  7. (Optional) Run network-authen-type { acceptance [ redirect-url url ] | dns-redirection | http-https-redirection redirect-url url | online-enroll }

    The authentication type of the Hotspot 2.0 network is configured.

    By default, no network authentication type is configured.

  8. (Optional) Run ipv4-address-avail { not-available | available | port-restricted [ single-nat | double-nat ] | private { single-nat | double-nat } | unknown }

    Available IPv4 address types of the Hotspot 2.0 network are configured.

    By default, no available type of IPv4 addresses is configured.

Translation
Download
Updated: 2018-12-24

Document ID: EDOC1100038361

Views: 147075

Downloads: 423

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next