No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - WLAN-AC

S5700 and S6720 V200R012C00

This document describes the configurations of WLAN, including WLAN Service Configuration, Radio Resource Management, Roaming, WLAN QoS, WLAN Security, WDS, Mesh, Location, Hotspot 2.0, Dual-Link Cold Backup, N+1 Backup.
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
AP Group and AP

AP Group and AP

To simplify the configuration of a large number of APs, you can add them to an AP group and perform centralized configuration.

However, APs may have different configurations. These configurations cannot be uniformly performed but can be directly performed on each AP.

Each AP must and can only join one AP group when going online. If an AP obtains both AP group and specific configurations from an AC, the AP specific configurations are preferentially used.
  • If no configuration is available on each AP, the AP uses the configurations in the AP group.
  • If configurations are available on the AP, the AP uses the configurations preferentially. However, if the configurations are incomplete, the AP obtains the configurations that do not exist on itself from the AP group.
  • Performance of APs in an AP group may vary according to the model. If the unified configuration delivered to the AP group is not supported by an AP in the group, the configuration does not take effect for this AP.
As shown in Figure 3-3, the AP with ID 1 does not find any configurations on itself; therefore, the AP uses all WLAN configurations in the AP group a to which it belongs.
Figure 3-3  AP group
As shown in Figure 3-4, the AP with ID 101 finds configurations on itself so the AP preferentially uses the configurations. Since there is only regulatory domain profile configuration on the AP, the AP acquires other configurations in AP group a to which it belongs, for example, VAP profile, AP system profile, and other profiles shown in the following figure.
Figure 3-4  AP group and AP
Translation
Download
Updated: 2018-12-24

Document ID: EDOC1100038361

Views: 110584

Downloads: 368

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next