No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Configuration Guide - WLAN-AC

S5700 and S6720 V200R012C00

This document describes the configurations of WLAN, including WLAN Service Configuration, Radio Resource Management, Roaming, WLAN QoS, WLAN Security, WDS, Mesh, Location, Hotspot 2.0, Dual-Link Cold Backup, N+1 Backup.

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring Attack Detection and a Dynamic Blacklist

Configuring Attack Detection and a Dynamic Blacklist

Pre-configuration Tasks

Table 10-5  Pre-configuration tasks



Create an AP group

Each AP will be added and can be added to only one AP group. An AP group is typically used to provide the same configurations for multiple APs. By default, the system has an AP group default. To create an AP group, execute this task. For details, see Creating an AP Group.

Configure an AP to go online

Configure a DHCP server

To go online normally, APs and STAs must obtain IP addresses. You can configure an AC as a DHCP server or use an independent DHCP server to allocate IP addresses to APs and STAs. For details, see Configuring a DHCP Server.

Configure network interconnections

To enable APs and STAs to obtain IP addresses, APs to discover the AC and go online on the AC, and STAs to access the network, configure interconnections between network devices. For details, see Configuring Network Interconnections.

Configure country codes

Correct country code configuration ensures that radio attributes of APs comply with laws and regulations of countries and regions to which the APs are delivered. For details, see Configuring Country Codes.

, radio parameters in compliance with local laws and regulations, such as the working channel and power

Configure a source interface

Before an AP establishes a CAPWAP tunnel with an AC, a source interface or source address must be specified for the AC. For details, see Configuring a Source Interface or Source Address.

Add APs

You can add APs in any of the following modes:
  • Importing APs offline
  • Configuring AC to automatically discover an AP
  • Manually confirming APs added to the list of unauthorized APs
Adding an AP offline is recommended when the MAC address or SN of the AP is already learned. For details, see Adding APs.

Configuration Procedure

Perform the following steps in the listed order.

Updated: 2018-12-24

Document ID: EDOC1100038361

Views: 209512

Downloads: 518

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Previous Next