No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Configuration Guide - WLAN-AC

S5700 and S6720 V200R012C00

This document describes the configurations of WLAN, including WLAN Service Configuration, Radio Resource Management, Roaming, WLAN QoS, WLAN Security, WDS, Mesh, Location, Hotspot 2.0, Dual-Link Cold Backup, N+1 Backup.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Delivering Configurations

Delivering Configurations


Configurations in the AP provisioning view are not automatically delivered to APs. You have to manually deliver them to APs.

After the configuration is committed, the AP receives the configuration and compares the configuration with its local configuration.
  • If they are consistent, the AP does not process the received configuration.
  • If they are different, the AP saves the committed configuration and automatically restarts, and the received configuration takes effect.

If the name or static IP address of an AP is specified in the AP provisioning view, the configuration is delivered only to the AP by specifying the AP name or MAC address, but cannot be delivered to APs in the specified AP group.

If you commit configurations to a large number of APs simultaneously, some of the APs may fail to receive the configurations. In this case, you are advised to commit the configurations again.


  1. Run system-view

    The system view is displayed.

  2. Run wlan

    The WLAN view is displayed.

  3. Run provision-ap

    The AP provisioning view is displayed.

  4. Run commit { ap-name ap-name | ap-mac ap-mac-address | ap-id ap-id | ap-group ap-group-name | all }

    The configurations are delivered to an AP, a group of APs, or all APs.

Updated: 2018-12-24

Document ID: EDOC1100038361

Views: 157939

Downloads: 436

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next