No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Configuration Guide - WLAN-AC

S5700 and S6720 V200R012C00

This document describes the configurations of WLAN, including WLAN Service Configuration, Radio Resource Management, Roaming, WLAN QoS, WLAN Security, WDS, Mesh, Location, Hotspot 2.0, Dual-Link Cold Backup, N+1 Backup.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Implementation Precautions for the Enterprise IoT Solution - Energy Efficiency Management

Implementation Precautions for the Enterprise IoT Solution - Energy Efficiency Management

Software and Hardware Installation Precautions

Perform the following operations at the terminal layer when deploying this solution on the live network:
  • Replace mechanical switches with smart wall switches, dimmer switches, or single-controlled modules.

  • Replace mechanical sockets with smart sockets.

  • Install three-phase load switches to connect to and control air conditioners.

  • Install brightness and motion sensors to sense human motions and monitor brightness indoors.

  • Install temperature and humidity sensors to monitor the temperature and humidity indoors.

Network Planning Precautions
  • ZigBee cards work on the 2.4 GHz frequency band. Therefore, during network planning and deployment, avoid using 2.4 GHz Wi-Fi channels. You can modify the band for ZigBee cards using the BEMS.

  • Mesh networks can be established between sensors and ZigBee cards. One mesh network can have a maximum of 50 nodes and a maximum of four hops. The distance between neighboring mesh nodes cannot exceed 25 m. No configuration for the mesh networking is required on the AC.

Service Planning Precautions

  • It is recommended that the APs connected to the same host computer be added to the same AP group.

Updated: 2018-12-24

Document ID: EDOC1100038361

Views: 160866

Downloads: 445

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next