No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - WLAN-AC

S5700 and S6720 V200R012C00

This document describes the configurations of WLAN, including WLAN Service Configuration, Radio Resource Management, Roaming, WLAN QoS, WLAN Security, WDS, Mesh, Location, Hotspot 2.0, Dual-Link Cold Backup, N+1 Backup.
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring IGMP Snooping

Configuring IGMP Snooping

Context

IGMP snooping is a basic Layer 2 multicast function that forwards and controls multicast traffic at the data link layer. IGMP snooping runs on a Layer 2 device and analyzes IGMP messages exchanged between a Layer 3 device and hosts to set up and maintain a Layer 2 multicast forwarding table. The Layer 2 device forwards multicast packets based on the Layer 2 multicast forwarding table.

Pre-configuration Tasks

Before configuring IGMP snooping, perform the task of WLAN Service Configuration.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run wlan

    The WLAN view is displayed.

  3. Run traffic-profile name profile-name

    A traffic profile is created, and the traffic profile view is displayed.

    By default, the system provides the traffic profile default.

  4. Run igmp-snooping enable

    IGMP snooping is enabled in the traffic profile.

    By default, IGMP snooping is disabled in a traffic profile.

  5. (Optional) Run igmp-snooping report-suppress

    Suppression of IGMP Report and Leave messages is enabled in the traffic profile.

    By default, IGMP Report and Leave message suppression is disabled in a traffic profile.

  6. Run quit

    Return to the WLAN view.

  7. Run vap-profile name profile-name

    The VAP profile view is displayed.

  8. Run traffic-profile profile-name

    The traffic profile is bound to the VAP profile.

    By default, the traffic profile default is bound to a VAP profile.

Verifying the Configuration

  • Run the display traffic-profile { all | name profile-name } command to check the IGMP snooping configuration in a traffic profile.

Translation
Download
Updated: 2018-12-24

Document ID: EDOC1100038361

Views: 111002

Downloads: 368

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next