No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Configuration Guide - WLAN-AC

S5700 and S6720 V200R012C00

This document describes the configurations of WLAN, including WLAN Service Configuration, Radio Resource Management, Roaming, WLAN QoS, WLAN Security, WDS, Mesh, Location, Hotspot 2.0, Dual-Link Cold Backup, N+1 Backup.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Resetting an AP

Resetting an AP


If an AP cannot work properly after being upgraded, reset the AP. You can run the display ap all command to check the AP State field to determine whether an AP is working properly. If the State field displays name-conflicted, ver-mismatch, config, config-failed, committing, or commit-failed, an AP fails to work properly.

Exercise caution when resetting an AP because services on the AP will be interrupted.


  1. Run system-view

    The system view is displayed.

  2. Run wlan

    The WLAN view is displayed.

  3. Run ap-reset { all | ap-name ap-name | ap-mac ap-mac | ap-id ap-id | ap-group ap-group | ap-type { type type-name | type-id type-id } }

    APs are reset.

Updated: 2018-12-24

Document ID: EDOC1100038361

Views: 158506

Downloads: 436

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next