No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - WLAN-AC

S5700 and S6720 V200R012C00

This document describes the configurations of WLAN, including WLAN Service Configuration, Radio Resource Management, Roaming, WLAN QoS, WLAN Security, WDS, Mesh, Location, Hotspot 2.0, Dual-Link Cold Backup, N+1 Backup.
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Creating an AP Group

Creating an AP Group

Context

On an AC + Fit AP network, one AC manages many APs. Usually, you need to perform the same configurations on the APs. In this situation, you can add the APs to an AP group and perform configurations uniformly in the AP group, which simplifies operations. All APs in the group use the same configurations.

Each AP must and can only join one AP group. An AP group contains configurations shared by all APs. You can configure configurations specific to a single AP in the AP view.

By default, an AP automatically joins the AP group default. The AP group default cannot be deleted, but you can modify configurations in the default AP group.

By default, an AP group has the following profiles bound: AP system profile default, 2G radio profile default, 5G radio profile default, regulatory domain profile default, WIDS profile default, and AP wired port profile default.

Pre-configuration Tasks

Before creating an AP group, perform the task of CLI Login Configuration.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run wlan

    The WLAN view is displayed.

  3. Run ap-group name group-name

    An AP group is created, and the AP group view is displayed.

    By default, the system provides the AP group default.

Verifying the Configuration

  • Run the display ap-group { all | name group-name } command to view AP group configurations.

Follow-up Procedure

After an AP group is created, you need to add APs to the AP group so that the APs can use configurations in the group. For details, see Adding APs.

Translation
Download
Updated: 2018-12-24

Document ID: EDOC1100038361

Views: 110309

Downloads: 368

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next