No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - WLAN-AC

S5700 and S6720 V200R012C00

This document describes the configurations of WLAN, including WLAN Service Configuration, Radio Resource Management, Roaming, WLAN QoS, WLAN Security, WDS, Mesh, Location, Hotspot 2.0, Dual-Link Cold Backup, N+1 Backup.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
(Optional) Configuring the LLDP Power Capacity Negotiation

(Optional) Configuring the LLDP Power Capacity Negotiation

Context

You can configure the TLV in LLDP so that the device can classify PDs through the LLDP function enabled on the device. The device that is not configured with the LLDP function detects and classifies PDs through analyzing current and resistance between the device and PDs. Compared with current and resistance analysis, the LLDP function provides a more comprehensive and accurate analysis.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run wlan

    The WLAN view is displayed.

  3. Run ap lldp enable

    LLDP is enabled in the WLAN view.

    By default, LLDP is enabled in the WLAN view.

  4. Run the port-link-profile name profile-name command to create an AP wired port link profile and enter the AP wired port link profile view.

    By default, the system provides the AP wired port link profile default.

  5. Run the lldp enable command to enable LLDP on an AP wired port.

    By default, LLDP is enabled on AP wired interfaces.

    NOTE:

    An AP can send and receive LLDP packets only after LLDP is enabled in both the WLAN view and the AP wired port link profile view.

  6. Run lldp tlv-enable dot3-tlv power

    LLDP is configured to advertise Power Via MDI TLV.

    By default, LLDP is configured to advertise Power Via MDI TLV.

    NOTE:
    After LLDP is configured advertise Power Via MDI TLV, the device can analyze the interface type, whether the PSE supports MDI, status of MDI power supply, whether the PSE can control the line pairs and analyze the line pairs and power priority.

  7. Run lldp dot3-tlv power { 802.1ab | 802.3at }

    The standard with which the 802.3 Power via MDI TLV sent by the interface complies is set.

    By default, the 802.3 Power via MDI TLV advertised by a UPoE interface and a PoE interface complies with 802.3bt and 802.3at, respectively.

  8. (Optional) Run lldp tlv-enable legacy-tlv four-pair-power

    The AP wired port is configured to advertise Cisco's proprietary TLVs.

    By default, an AP's wired interface advertises Cisco's proprietary TLVs.

Translation
Download
Updated: 2018-12-24

Document ID: EDOC1100038361

Views: 160861

Downloads: 445

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next