No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - WLAN-AC

S5700 and S6720 V200R012C00

This document describes the configurations of WLAN, including WLAN Service Configuration, Radio Resource Management, Roaming, WLAN QoS, WLAN Security, WDS, Mesh, Location, Hotspot 2.0, Dual-Link Cold Backup, N+1 Backup.
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Setting the Working Mode for the Central AP's Wired Interface

Setting the Working Mode for the Central AP's Wired Interface

Context

When the central AP is connected to RUs, set the working mode of the central AP's downlink interfaces to middle.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run wlan

    The WLAN view is displayed.

  3. Run the wired-port-profile name profile-name command to create an AP wired port profile and enter the profile view.

    By default, the system provides the AP wired port profile default.

  4. Run the mode middle command to set the working mode of the AP's wired interface to middle.

    By default,
    • On a common AP: Its GE interfaces work in root mode, Ethernet interfaces in endpoint mode, and Eth-Trunk interfaces in root mode.
    • On a central AP: Its uplink GE interfaces in root mode and downlink GE interfaces work in middle mode.
    • On an R230D: Its Ethernet interface works in root mode.
    • On an R240D: Its Ethernet interface works in endpoint mode and GE interface in root mode.
    • On an R250D, R250D-E, AP2050DN, AP2051DN, AP2051DN-E, R251D, R251D-E and AP2050DN-E: Their uplink GE interfaces work in root mode and downlink GE interfaces in endpoint mode.
    • On an R450D: Its GE interface works in root mode.

    After changing the working mode of the central AP's wired interfaces, restart the AP to make the change effective.

  5. Run quit

    Return to the WLAN view.

  6. Bind the AP wired port profile to the central AP.

    1. Run the ap-id ap-id, ap-mac ap-mac, or ap-name ap-name command to enter the AP view.
    2. Run the wired-port-profile profile-name interface-type interface-number command to bind the AP wired port profile to the AP.

      By default, no AP wired port profile is bound to an AP.

Translation
Download
Updated: 2018-12-24

Document ID: EDOC1100038361

Views: 123419

Downloads: 379

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next