No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - WLAN-AC

S5700 and S6720 V200R012C00

This document describes the configurations of WLAN, including WLAN Service Configuration, Radio Resource Management, Roaming, WLAN QoS, WLAN Security, WDS, Mesh, Location, Hotspot 2.0, Dual-Link Cold Backup, N+1 Backup.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring the Radio Working Mode

Configuring the Radio Working Mode

Context

Before configuring rogue device detection and containment, you need to configure the radio working mode to determine whether a radio only transmits common WLAN services or both transmits common WLAN services and performs the monitoring function.

An AP can work in two modes:
  • normal: indicates the normal mode.
    • If the air scan function is disabled on a radio, including WIDS, spectrum analysis, and terminal location, the radio is used to transmit common WLAN services.
    • If the air scan function is enabled on a radio, the radio transmits common WLAN services and also implements detection. Transmission of common WLAN services may be affected.
  • monitor: indicates the monitor mode.

    In this mode, the radio can only transmit WLAN services scanned by the air interface but cannot transmit common WLAN services.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run wlan

    The WLAN view is displayed.

  3. Set the working mode for radios in an AP group or for a specified radio.

    You can set the radio working mode in the AP radio view or AP group radio view. The configuration in the AP group radio view takes effect on all AP radios in an AP group and that in the AP radio view takes effect only on a specified AP radio. The configuration in the AP radio view has a higher priority than that in the AP group radio view.

    • Set the working mode for all radios in an AP group.
      1. Run the ap-group name group-name command to enter the AP group view.
      2. Run the radio radio-id command to enter the radio view.
      3. Run the work-mode { normal | monitor [ dual-band-scan enable ] } command to set the working mode for radios in an AP group.

        By default, radios in an AP group work in normal mode.

      4. Run the quit command to return to the AP group view.

    • Set the working mode for a specified AP radio.
      1. Run the ap-id ap-id, ap-mac ap-mac, or ap-name ap-name command to enter the AP view.
      2. Run the radio radio-id command to enter the radio view.
      3. Run the work-mode { normal | monitor [ dual-band-scan enable ] } command to set the working mode for a specified AP radio.

        By default, an AP radio works in normal mode.

      4. Run the quit command to return to the AP view.

Translation
Download
Updated: 2018-12-24

Document ID: EDOC1100038361

Views: 146671

Downloads: 423

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next