No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Configuration Guide - WLAN-AC

S5700 and S6720 V200R012C00

This document describes the configurations of WLAN, including WLAN Service Configuration, Radio Resource Management, Roaming, WLAN QoS, WLAN Security, WDS, Mesh, Location, Hotspot 2.0, Dual-Link Cold Backup, N+1 Backup.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring ACL-based Priority Remarking

Configuring ACL-based Priority Remarking


By configuring ACL-based priority remarking, the device remarks the priorities of wireless packets matching ACL rules to provide differentiated services.

Pre-configuration Tasks

Before configuring ACL-based priority remarking, complete the following tasks:


  1. Run system-view

    The system view is displayed.

  2. Run wlan

    The WLAN view is displayed.

  3. Run traffic-profile name profile-name

    A traffic profile is created and the traffic profile view is displayed.

    By default, the system provides the traffic profile default.

  4. Run the traffic-remark { inbound | outbound } ipv4 acl { acl-number | name acl-name } { dot11e dot11e-value | dscp dscp-value } to configure ACL-based priority remarking in the traffic profile.

    By default, ACL-based priority re-marking is not configured in a traffic profile.

    The traffic-remark command can reference a numbered ACL rule that is not configured. You can configure the referenced ACL rule after running this command.

    You can only configure a maximum of eight ACL-based packet re-marking rules in the same direction. The sequence in which ACL rules takes effect follows the rule configuration sequence. To change the current packet re-marking rules, delete all the related configurations and reconfigure the ACL-based packet re-marking.

  5. Run quit

    Return to the WLAN view.

  6. Run vap-profile name profile-name

    The VAP profile view is displayed.

  7. Run traffic-profile profile-name

    The traffic profile is bound to the VAP profile.

    By default, the traffic profile default is bound to a VAP profile.

Updated: 2018-12-24

Document ID: EDOC1100038361

Views: 161061

Downloads: 445

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next