No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Configuration Guide - WLAN-AC

S5700 and S6720 V200R012C00

This document describes the configurations of WLAN, including WLAN Service Configuration, Radio Resource Management, Roaming, WLAN QoS, WLAN Security, WDS, Mesh, Location, Hotspot 2.0, Dual-Link Cold Backup, N+1 Backup.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Application Scenarios for Mesh

Application Scenarios for Mesh

Mesh Wireless Bridging

In Figure 14-4, AP1 to AP3 provide network access service for wired and wireless users. The three APs, however, cannot access the Internet in wired mode because of geographical or environmental restrictions. AP1 to AP3 can work with AP4 to build a WMN so that wireless users can connect to the Internet.

Figure 14-4  Mesh wireless bridging

WMN with One MPP

In Figure 14-5, AP2 to AP5 provide network access service for wireless users, and AP1 provides wired access to the Internet. AP1 to AP5 are fully meshed to establish a secure, auto-configured, and self-healing outdoor WMN, which facilitates fast and cost-effective WLAN deployment in outdoor environment where cabling is difficult.

Figure 14-5  WMN with one MPP

WMN with Multiple MPPs

In Figure 14-6, AP1 and AP11 provide wired access to the Internet. AP2 to AP5 provide network access service for wired and wireless users in Area 1, and AP7 to AP10 provide network access service for wired and wireless users in Area 2. AP6 resides in the overlapping area between Area 1 and Area 2.

An MPP and MPs that establish mesh links with the MPP use the same wireless channels. If network access service needs to be provided for different areas, multiple MPPs need to work in different channels to prevent MPs from preempting wireless channels and improve coverage performance. Each MP can select the MPP with the minimum hops from the MP as the gateway to connect the wired network.

Figure 14-6  WMN with multiple MPPs

Updated: 2018-12-24

Document ID: EDOC1100038361

Views: 158835

Downloads: 436

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next