No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - WLAN-AC

S5700 and S6720 V200R012C00

This document describes the configurations of WLAN, including WLAN Service Configuration, Radio Resource Management, Roaming, WLAN QoS, WLAN Security, WDS, Mesh, Location, Hotspot 2.0, Dual-Link Cold Backup, N+1 Backup.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Common Operations of Profiles

Common Operations of Profiles

Copying Profiles

To improve configuration efficiency, you can copy configurations in one profile to another profile and then modify specific parameters.

For example, if you need to copy the configurations in VAP profile b to VAP profile a, you only need to run the copy-from profile-name command in VAP profile a. The detailed procedure is as follows:
<HUAWEI> system-view
[HUAWEI] wlan
[HUAWEI-wlan-view] vap-profile name a
[HUAWEI-wlan-vap-prof-a] copy-from b
NOTE:
  • You can perform this operation only between profiles of the same type. For example, you can copy the configurations in a VAP profile to another VAP profile other than a radio profile.

  • If a profile is bound to another profile, you cannot perform this operation in this profile. For example, if VAP profile a is bound to an AP group, you cannot perform this operation in VAP profile a.

Viewing Reference Information About a Profile

After configuring a profile, you can run the display references profile-type name profile-name command to view to which profiles it is bound. profile-type indicates the name of a profile type. You can run the display references ? command in any view to view all profile-type available for viewing and description. For example, you can run the display references radio-2g-profile name default command to view the profiles to which 2G radio profile default is bound.

Translation
Download
Updated: 2018-12-24

Document ID: EDOC1100038361

Views: 150640

Downloads: 427

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next