No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Configuration Guide - WLAN-AC

S5700 and S6720 V200R012C00

This document describes the configurations of WLAN, including WLAN Service Configuration, Radio Resource Management, Roaming, WLAN QoS, WLAN Security, WDS, Mesh, Location, Hotspot 2.0, Dual-Link Cold Backup, N+1 Backup.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Enabling the PoE Function

Enabling the PoE Function


Before using an AP to provide power for PDs connected to its interfaces, ensure that the PoE function is enabled on the interfaces.


  1. Run system-view

    The system view is displayed.

  2. Run wlan

    The WLAN view is displayed.

  3. Run the port-link-profile name profile-name command to create an AP wired port link profile and enter the profile view.

    By default, the system provides the AP wired port link profile default.

  4. Run the undo poe disable command to enable the PoE function on the AP's interfaces.

    By default, the PoE function is enabled on an AP's interface.

Updated: 2018-12-24

Document ID: EDOC1100038361

Views: 147440

Downloads: 423

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next