No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - WLAN-AC

S5700 and S6720 V200R012C00

This document describes the configurations of WLAN, including WLAN Service Configuration, Radio Resource Management, Roaming, WLAN QoS, WLAN Security, WDS, Mesh, Location, Hotspot 2.0, Dual-Link Cold Backup, N+1 Backup.
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring Option 43 on the DHCP Server

Configuring Option 43 on the DHCP Server

Context

If an AP and the ACs are located in different network segments, the AP cannot discover the ACs through broadcast after it obtains an IP address from the DHCP server. To address this problem, configure Option 43 on the DHCP server to advertise AC IP addresses to the AP.

After Option 43 is configured, the AP unicasts Discovery Request packets to the IP addresses carried in Option 43. If the IP addresses specified by Option 43 do not respond, the AP broadcasts Discovery Request packets to request IP addresses of the ACs in the local network segment. Option 43 only needs to carry addresses of the active and standby ACs for the AP and does not carry irrelevant active ACs' IP addresses; otherwise, the AP may not connect to the correct AC.

Usually, an independent device is used as a DHCP server. Perform correct configurations on the selected DHCP server. The following example uses a Huawei router as a DHCP server.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run dhcp enable

    DHCP is enabled.

    By default, DHCP is disabled.

  3. Run ip pool ip-pool-name

    The global address pool view is displayed.

  4. Run option 43 sub-option 2 ip-address ip-address &<1-8>

    The Option 43 field is set to the IP addresses of the active AC and standby AC.

Translation
Download
Updated: 2018-12-24

Document ID: EDOC1100038361

Views: 124358

Downloads: 380

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next