No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - WLAN-AC

S5700 and S6720 V200R012C00

This document describes the configurations of WLAN, including WLAN Service Configuration, Radio Resource Management, Roaming, WLAN QoS, WLAN Security, WDS, Mesh, Location, Hotspot 2.0, Dual-Link Cold Backup, N+1 Backup.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring Revertive Switchover

Configuring Revertive Switchover

Context

After an active/standby AC switchover, the standby AC replaces the active AC and sets up a CAPWAP link with the AP to provide services. The AP periodically sends Primary Discovery Request packets to detect active AC status. If revertive switchover is enabled on the standby AC, the AP triggers a revertive switchover when it detects that the active AC recovers. The AP disconnects from the current AC and sets up a new CAPWAP link with the active AC. Resources on the standby AC are released and the standby AC then continues to provide backup services.

Revertive switchover needs to be enabled only on the standby AC.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run wlan

    The WLAN view is displayed.

  3. Run undo ac protect restore disable

    Revertive switchover is enabled.

    By default, global revertive switching is enabled.

    NOTE:
    If revertive switchover is disabled on the standby AC, traffic of an AP cannot be switched back to the original active AC even when the link between the original active AC and the AP restores.

Translation
Download
Updated: 2018-12-24

Document ID: EDOC1100038361

Views: 161358

Downloads: 445

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next