No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - WLAN-AC

S5700 and S6720 V200R012C00

This document describes the configurations of WLAN, including WLAN Service Configuration, Radio Resource Management, Roaming, WLAN QoS, WLAN Security, WDS, Mesh, Location, Hotspot 2.0, Dual-Link Cold Backup, N+1 Backup.
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring the AP Channel Mode

Configuring the AP Channel Mode

Context

In scenarios where indoor and outdoor boundaries are unclear, such as subway and train platforms, it is recommended that outdoor APs be deployed. When a large volume of data is transmitted, outdoor APs in outdoor channel mode have no sufficient channels to meet data transmission requirements. In this case, you can run the channel-load-mode indoor command to set the channel mode of the APs to indoor mode, so that data can be transmitted on more channels.

NOTE:

This function is supported only by the AP8030DN, AP8130DN, AP8050TN-HD, AP8050DN, AP8150DN, AP8050DN-S, AP8082DN and AP8182DN.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run wlan

    The WLAN view is displayed.

  3. Run regulatory-domain-profile name profile-name

    A regulatory domain profile is created, and the regulatory domain profile view is displayed.

    By default, the system provides the regulatory domain profile default.

  4. Run channel-load-mode indoor

    The AP channel mode is set to indoor mode.

    The default channel mode of an AP is outdoor mode.

  5. Run quit

    Return to the WLAN view.

  6. Bind the regulatory domain profile to an AP group or AP.

    • Binding the regulatory domain profile to an AP group
      1. Run the ap-group name group-name command to enter the AP group view.

      2. Run the regulatory-domain-profile profile-name command to bind the regulatory domain profile to the AP group.

        By default, the regulatory domain profile default is bound to an AP group.

    • Binding the regulatory domain profile to an AP
      1. Run the ap-id ap-id, ap-mac ap-mac, or ap-name ap-name command to enter the AP view.
      2. Run the regulatory-domain-profile profile-name command to bind the regulatory domain profile to the AP.

        By default, no regulatory domain profile is bound to an AP.

Translation
Download
Updated: 2018-12-24

Document ID: EDOC1100038361

Views: 128151

Downloads: 383

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next