No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - WLAN-AC

S5700 and S6720 V200R012C00

This document describes the configurations of WLAN, including WLAN Service Configuration, Radio Resource Management, Roaming, WLAN QoS, WLAN Security, WDS, Mesh, Location, Hotspot 2.0, Dual-Link Cold Backup, N+1 Backup.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring AP Online Parameters

Configuring AP Online Parameters

Context

By default, no online parameters are configured on APs in the AP view. If AP online parameters are configured in the AP view, run the display ap provision command to display the configurations.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run wlan

    The WLAN view is displayed.

  3. Run ap-id ap-id, ap-mac ap-mac, or ap-name ap-name

    The AP view is displayed.

  4. Run ap-name ap-new-name

    A name is configured for an AP.

    By default, no AP name is configured for an AP.

    NOTE:

    The new AP name cannot be the same as the existing AP name.

  5. Run ap-group ap-group

    The AP group to which an AP belongs is modified.

    By default, no AP group is configured.

  6. Run address-mode { dhcp | static }

    The method used by an AP to obtain an IPv4 address is configured.

    By default, the mode in which an AP obtains an IP address is not configured.

  7. (Optional) Run ip-address ip-address { mask-length | mask } [ gateway gateway ]

    A static IPv4 address and gateway for an AP are configured.

    By default, no static IPv4 address and gateway are configured for an AP.

    NOTE:

    This step is performed only if APs obtain IP addresses in static mode.

  8. Run ac-list ipv4-address &<1-4>

    An AC IPv4 address list for an AP is configured.

    By default, no AC IPv4 address list is configured.

Verifying the Configuration

  • Run the display ap provision ap-id ap-id command to display the parameter configurations in the AP view.
Translation
Download
Updated: 2018-12-24

Document ID: EDOC1100038361

Views: 149450

Downloads: 427

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next