No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - WLAN-AC

S5700 and S6720 V200R012C00

This document describes the configurations of WLAN, including WLAN Service Configuration, Radio Resource Management, Roaming, WLAN QoS, WLAN Security, WDS, Mesh, Location, Hotspot 2.0, Dual-Link Cold Backup, N+1 Backup.
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring Flood Attack Detection

Configuring Flood Attack Detection

Context

A large number of broadcast or multicast packets on a device occupy many network resources, affecting network services. To ensure normal running of network services, you can limit the rate of broadcast and multicast packets on APs with a proper range.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run wlan

    The WLAN view is displayed.

  3. Run vap-profile name profile-name

    The VAP profile view is displayed.

  4. Configure flood attack detection.

    • Configure broadcast flood attack detection.
      1. Run the undo anti-attack broadcast-flood disable command to enable flood attack detection.

        By default, the broadcast flood detection function is enabled.

      2. Run the anti-attack broadcast-flood sta-rate-threshold sta-rate-threshold command to set the rate threshold for broadcast flood attack detection.

        By default, the broadcast flood threshold is 10 pps.

      3. (Optional) Run the anti-attack broadcast-flood blacklist enable command to enable the broadcast flood blacklist function. The device then adds STAs that launch broadcast flood attacks to the blacklist.

        By default, the broadcast flood blacklist function is disabled.

Translation
Download
Updated: 2018-12-24

Document ID: EDOC1100038361

Views: 124631

Downloads: 380

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next