No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - WLAN-AC

S5700 and S6720 V200R012C00

This document describes the configurations of WLAN, including WLAN Service Configuration, Radio Resource Management, Roaming, WLAN QoS, WLAN Security, WDS, Mesh, Location, Hotspot 2.0, Dual-Link Cold Backup, N+1 Backup.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring Network Interworking

Configuring Network Interworking

Configure network interworking of network elements (NEs) to ensure proper data transmission.

Configuring Management Packet Exchange

Management packets between an AC and APs are transmitted only on the network between them. To ensure that the AC and APs exchange management packets properly, configure correct VLANs or routes.

Configuring Service Packet Exchange

Service packets are transmitted between STAs and the upper-layer network. Configure service packet exchange to ensure proper transmission of service packets.

Configuring APs and STAs to Communicate with a DHCP Server

APs and STAs must obtain IP addresses from a DHCP server; therefore, you need to configure the APs and STAs to communicate with the DHCP server.

Configuring APs to Communicate with the EBT and Niagara Container

An AP needs to establish the first channel with the Niagara container on the IoT gateway and an extended channel with the EBT. Therefore, the AP must interwork with the Niagara container and EBT.

Configuring Interworking Between the EMS, EEM, and IoT Gateway

The EMS, EEM, and IoT gateway need to exchange energy efficiency management policies and data reported by sensors. Therefore, network connectivity between them must be ensured.

Translation
Download
Updated: 2018-12-24

Document ID: EDOC1100038361

Views: 149532

Downloads: 427

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next