No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - WLAN-AC

S5700 and S6720 V200R012C00

This document describes the configurations of WLAN, including WLAN Service Configuration, Radio Resource Management, Roaming, WLAN QoS, WLAN Security, WDS, Mesh, Location, Hotspot 2.0, Dual-Link Cold Backup, N+1 Backup.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring Automatic Per Packet Power Adjustment

Configuring Automatic Per Packet Power Adjustment

Context

You can configure automatic per packet power adjustment on WLANs to reduce AP power consumption and interference to surrounding devices. This configuration applies to WLANs with good signal coverage.

Pre-configuration Tasks

Before configuring automatic per packet power adjustment, perform the task of WLAN Service Configuration.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run wlan

    The WLAN view is displayed.

  3. Run radio-2g-profile name profile-name or radio-5g-profile name profile-name

    The 2G or 5G radio profile view is displayed.

  4. Run power auto-adjust enable

    Automatic per packet power adjustment is enabled for APs.

    By default, automatic per packet power adjustment is disabled for an AP.

  5. Run quit

    Return to the WLAN view.

  6. Bind the radio profile to an AP group or a specific AP. For the detailed procedure, see Binding a Radio Profile.

Verifying the Configuration

  • Run the display radio-2g-profile name profile-name command to check the automatic per packet power adjustment configuration of an AP in a 2G radio profile.
  • Run the display radio-5g-profile name profile-name command to check the automatic per packet power adjustment configuration of an AP in a 5G radio profile.
Translation
Download
Updated: 2018-12-24

Document ID: EDOC1100038361

Views: 158833

Downloads: 436

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next