No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

S12700 V200R012C00 Configuration Guide - QoS

This document describes the configurations of QoS functions, including MQC, priority mapping, traffic policing, traffic shaping, interface-based rate limiting, congestion avoidance, congestion management, packet filtering, redirection, traffic statistics, ACL-based simplified traffic policy, and HQoS.
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring Inbound Interface-based Rate Limiting

Configuring Inbound Interface-based Rate Limiting

Context

If rates of traffic sent from users are not limited, continuous burst data from many users congests the network. Inbound interface-based rate limiting controls the rate of traffic entering an interface within a specified range.

Procedure

  1. Run system-view

    The system view is displayed.

  2. (Optional) Run qos-car exclude-interframe

    The system is configured not to count the inter-frame gap and preamble of packets when calculating inbound interface-based rate limiting.

    By default, the system counts the inter-frame gap and preamble of packets when calculating the traffic rate for inbound interface-based rate limiting.

  3. Run qos car car-name cir cir-value [ cbs cbs-value [ pbs pbs-value ] | pir pir-value [ cbs cbs-value pbs pbs-value ] ]

    A QoS CAR profile is created, and rate limiting parameters are configured in the profile.

  4. Run interface interface-type interface-number

    The interface view is displayed.

  5. Run qos car inbound car-name

    The QoS CAR profile is applied to the interface.

    After a CAR profile is applied to an interface, the device limits the rate of all traffic entering the interface.

    If a QoS CAR profile is applied to a VLAN to police incoming broadcast traffic, multicast traffic, or unknown unicast traffic (see the broadcast-suppression (VLAN view), multicast-suppression (VLAN view), or unicast-suppression (VLAN view) command) and a QoS CAR profile is applied to an interface that allows this VLAN, traffic suppression and rate limiting take effect in sequence on X series cards, but only QoS CAR parameters take effect on other cards.

Configuration Tips

Deleting the Configuration of Inbound Interface-based Rate Limiting

Unbind the QoS CAR profile qoscar1 from GE1/0/1 and delete the profile.

[HUAWEI] interface gigabitethernet 1/0/1
[HUAWEI-GigabitEthernet1/0/1] undo qos car inbound
[HUAWEI-GigabitEthernet1/0/1] quit
[HUAWEI] undo qos car qoscar1
Translation
Download
Updated: 2019-01-18

Document ID: EDOC1100038410

Views: 17704

Downloads: 24

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next