No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Ethernet Switching

S7700 and S9700 V200R012C00

This document describes the configuration of Ethernet services, including configuring MAC address table, link aggregation, VLANs, VLAN aggregation, MUX VLAN, VLAN termination, Voice VLAN, VLAN mapping, QinQ, GVRP, VCMP, STP/RSTP/MSTP, VBST, SEP, RRPP, ERPS, LBDT, HVRP, and Layer 2 protocol transparent transmission.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
(Optional) Disabling Revertive Switching on an E-Trunk

(Optional) Disabling Revertive Switching on an E-Trunk

Context

On devices in an E-Trunk, disabling revertive switching on the E-Trunk when the faulty master device recovers can prevent loss of traffic that is switched back.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run e-trunk e-trunk-id

    The E-Trunk view is displayed.

  3. Run revert disable

    Revertive switching is disabled on the E-Trunk.

    By default, revertive switching is enabled on an E-Trunk.

Translation
Download
Updated: 2019-01-18

Document ID: EDOC1100038843

Views: 117835

Downloads: 73

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next