No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Ethernet Switching

S7700 and S9700 V200R012C00

This document describes the configuration of Ethernet services, including configuring MAC address table, link aggregation, VLANs, VLAN aggregation, MUX VLAN, VLAN termination, Voice VLAN, VLAN mapping, QinQ, GVRP, VCMP, STP/RSTP/MSTP, VBST, SEP, RRPP, ERPS, LBDT, HVRP, and Layer 2 protocol transparent transmission.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
(Optional) Configuring the 802.1p Priority and DSCP Priority for a Voice VLAN

(Optional) Configuring the 802.1p Priority and DSCP Priority for a Voice VLAN

Context

By default, the 802.1p priority and DSCP priority for a voice VLAN are 6 and 46 respectively. You can dynamically configure 802.1p priority and DSCP priority to plan priorities for different voice services.
  • The 802.1p priority is indicated by the value in the 3-bit PRI field in each 802.1Q VLAN frame. This field determines the transmission priority for data packets when a switching device is congested.

  • The DSCP value is indicated by the 6 bits in the Type of Service (ToS) field in the IPv4 packet header. DSCP, as the signaling for DiffServ, is used for QoS guarantee on IP networks. The traffic controller on the network gateway takes actions merely based on the information carried by the 6 bits.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run voice-vlan remark { 8021p 8021p-value | dscp dscp-value } *

    The 802.1p priority and DSCP priority are configured for a voice VLAN.

    By default, the 802.1p priority and DSCP priority for a voice VLAN are 6 and 46 respectively.

    NOTE:

    When the outbound interface is located on the ES0D0G24SA00, ES0D0G24CA00, EH1D2S24CSA0, or EH1D2G24SSA0 cards, the 802.1p priority cannot be changed.

Translation
Download
Updated: 2019-01-18

Document ID: EDOC1100038843

Views: 109566

Downloads: 72

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next