No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Ethernet Switching

S7700 and S9700 V200R012C00

This document describes the configuration of Ethernet services, including configuring MAC address table, link aggregation, VLANs, VLAN aggregation, MUX VLAN, VLAN termination, Voice VLAN, VLAN mapping, QinQ, GVRP, VCMP, STP/RSTP/MSTP, VBST, SEP, RRPP, ERPS, LBDT, HVRP, and Layer 2 protocol transparent transmission.
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring the STP Timeout Interval

Configuring the STP Timeout Interval

Context

If a device does not receive any BPDUs from the upstream device within the timeout interval, the device considers the upstream device to have failed and recalculates the spanning tree.

Sometimes, a device cannot receive the BPDU from the upstream device within the timeout interval because the upstream device is busy. In this case, recalculating the spanning tree will cause a waste of network resources. To avoid wasting network resources, set a long timeout interval on a stable network.

If a device does not receive any BPDUs from the upstream device within the timeout interval, spanning tree recalculation is performed. The timeout interval is calculated as follows:

Timeout interval = Hello time x 3 x Timer Factor

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run stp timer-factor factor

    The Timer Factor value is set.

    By default, the timeout interval is 9 times the Hello timer value.

Translation
Download
Updated: 2019-01-18

Document ID: EDOC1100038843

Views: 94240

Downloads: 67

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next