No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Ethernet Switching

S7700 and S9700 V200R012C00

This document describes the configuration of Ethernet services, including configuring MAC address table, link aggregation, VLANs, VLAN aggregation, MUX VLAN, VLAN termination, Voice VLAN, VLAN mapping, QinQ, GVRP, VCMP, STP/RSTP/MSTP, VBST, SEP, RRPP, ERPS, LBDT, HVRP, and Layer 2 protocol transparent transmission.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Enabling RRPP Snooping

Enabling RRPP Snooping

Context

When RRPP snooping is enabled on an interface, the status of the RRPP ring can be detected through RRPP control packets. When the status of the RRPP ring changes, the interface requests the VSI bound to the interface to update its MAC address table.

NOTE:

RRPP and RRPP snooping cannot be simultaneously configured on the same interface.

Configure RRPP snooping only on the node connecting the RRPP ring to the VPLS network.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Entering the view of the interface to be enabled with RRPP snooping using the following commands as required

    • Run interface interface-type interface-number.subinterface-number

      The sub-interface view is displayed.

    • Run interface vlanif vlan-id

      The VLANIF interface view is displayed.

    Specifying that the sub-interface or VLANIF interface permits only the packets in the control VLAN of the RRPP domain to pass through.

  3. Run rrpp snooping enable

    RRPP snooping is enabled.

    Before running this command, bind the sub-interface or VLANIF interface to the VSI.

    If the sub-interface or VLANIF interface is removed from the VSI, RRPP snooping is automatically disabled on the interface.

    After RRPP snooping is enabled on the sub-interface or VLANIF interface, the sub-interface or VLANIF interface is automatically associated with the VSI.

    By default, RRPP snooping is disabled.

Translation
Download
Updated: 2019-01-18

Document ID: EDOC1100038843

Views: 95541

Downloads: 67

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next