No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Ethernet Switching

S7700 and S9700 V200R012C00

This document describes the configuration of Ethernet services, including configuring MAC address table, link aggregation, VLANs, VLAN aggregation, MUX VLAN, VLAN termination, Voice VLAN, VLAN mapping, QinQ, GVRP, VCMP, STP/RSTP/MSTP, VBST, SEP, RRPP, ERPS, LBDT, HVRP, and Layer 2 protocol transparent transmission.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Verifying the LDT Configuration

Verifying the LDT Configuration

Procedure

  1. Run the display loop-detection [ interface interface-type interface-number ] command to check the LDT configuration and interface status.

    If interface-type and interface-number are not specified, the status of the global LDT function is displayed. If the function is enabled, the system displays the interval for sending LDT packets, ID of the VLANs with this function enabled, detected loops, and actions taken on the interfaces where loops are detected.

    If interface-type and interface-number are specified, the system displays the interface status, interface recovery time, and LDT-enabled VLAN.

Translation
Download
Updated: 2019-01-18

Document ID: EDOC1100038843

Views: 108917

Downloads: 72

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next