No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Ethernet Switching

S7700 and S9700 V200R012C00

This document describes the configuration of Ethernet services, including configuring MAC address table, link aggregation, VLANs, VLAN aggregation, MUX VLAN, VLAN termination, Voice VLAN, VLAN mapping, QinQ, GVRP, VCMP, STP/RSTP/MSTP, VBST, SEP, RRPP, ERPS, LBDT, HVRP, and Layer 2 protocol transparent transmission.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring a Principal VLAN for MUX VLAN

Configuring a Principal VLAN for MUX VLAN

Context

Ports in a principal VLAN can communicate with other ports in the same MUX VLAN.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run vlan vlan-id

    A VLAN is created and the VLAN view is displayed. If the VLAN already exists, the VLAN view is displayed.

    The VLAN ID is in the range 1 to 4094. To create VLANs in a batch, run the vlan batch { vlan-id1 [ to vlan-id2 ] } &<1-10> command. Then run the vlan vlan-id command to enter the view of a specified VLAN.

    NOTE:

    If a switch is configured with multiple VLANs, configure names for the VLANs to facilitate VLAN management.

    Run the name vlan-name command in the VLAN view. After a VLAN name is configured, you can run the vlan vlan-name vlan-name command in the system view to enter the corresponding VLAN view.

  3. Run mux-vlan

    The VLAN is configured as a principal VLAN.

    The VLAN ID assigned to a principal VLAN cannot be used to configure VLAN mapping, VLAN stacking, super-VLAN, or sub-VLAN.

Translation
Download
Updated: 2019-01-18

Document ID: EDOC1100038843

Views: 107476

Downloads: 71

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next