No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Ethernet Switching

S7700 and S9700 V200R012C00

This document describes the configuration of Ethernet services, including configuring MAC address table, link aggregation, VLANs, VLAN aggregation, MUX VLAN, VLAN termination, Voice VLAN, VLAN mapping, QinQ, GVRP, VCMP, STP/RSTP/MSTP, VBST, SEP, RRPP, ERPS, LBDT, HVRP, and Layer 2 protocol transparent transmission.
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring a Dot1q Termination Sub-interface to Implement Inter-VLAN Communication

Configuring a Dot1q Termination Sub-interface to Implement Inter-VLAN Communication

Context

When a Layer 3 switch connects to users located in different VLANs through a Layer 3 Ethernet interface, configure Dot1q termination sub-interfaces on this Layer 3 Ethernet interface to implement inter-VLAN communication. This allows the users to communicate with each other.

NOTE:
  • To implement inter-VLAN communication, hosts in each VLAN must use the IP address of the corresponding sub-interface as the default gateway address.

  • When VLAN IDs terminated by a sub-interface are used for Layer 3 forwarding, only the first VLAN takes effect even if multiple inner VLAN IDs are specified.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run interface interface-type interface-number

    The interface view is displayed.

  3. Run port link-type { hybrid | trunk }

    The link type of the interface is set.

  4. Run quit

    Exit from the interface view.

  5. Run interface interface-type interface-number.subinterface-number

    The sub-interface view is displayed.

  6. Run ip address ip-address { mask | mask-length } [ sub ]

    An IP address is assigned to the sub-interface.

  7. Run dot1q termination vid low-pe-vid [ to high-pe-vid ]

    Dot1q termination is configured on the sub-interface.

    Sub-interfaces of different main interfaces can be associated with the same VLAN, whereas sub-interfaces of the same main interface cannot be associated with the same VLAN.

    NOTE:

    When VLAN IDs terminated by a sub-interface are used for Layer 3 forwarding, it is recommended that a maximum of 128 VLANs be in all VLAN ranges.

  8. Run arp broadcast enable

    ARP broadcast is enabled on the sub-interface.

    When you enable or disable ARP broadcast on a sub-interface, the routing status of the sub-interface alternates between Down and Up. This may result in route flapping on the entire network, affecting normal operation of services.

Translation
Download
Updated: 2019-01-18

Document ID: EDOC1100038843

Views: 93547

Downloads: 67

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next