No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Ethernet Switching

S7700 and S9700 V200R012C00

This document describes the configuration of Ethernet services, including configuring MAC address table, link aggregation, VLANs, VLAN aggregation, MUX VLAN, VLAN termination, Voice VLAN, VLAN mapping, QinQ, GVRP, VCMP, STP/RSTP/MSTP, VBST, SEP, RRPP, ERPS, LBDT, HVRP, and Layer 2 protocol transparent transmission.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
(Optional) Enabling Proxy ARP on the VLANIF Interface Corresponding to a Super-VLAN

(Optional) Enabling Proxy ARP on the VLANIF Interface Corresponding to a Super-VLAN

Context

VLAN aggregation does not support Layer 3 communication between hosts in different sub-VLANs. To enable hosts in one sub-VLAN to communicate with hosts in another sub-VLAN or on another network over Layer 3, enable proxy ARP. After a super-VLAN and its VLANIF interface are created, proxy ARP must be enabled to allow the super-VLAN to forward or process ARP Request and Reply packets.

NOTE:

This configuration enables hosts in all sub-VLANs of the super-VLAN to communicate with each other. If PCs in some sub-VLANs of the super-VLAN need to communicate, see How Do I Implement Communication Between Specific Sub-VLANs in a Super-VLAN.

VLAN aggregation simplifies configurations for networks where many VLANs are configured and PCs in different VLANs need to communicate with each other.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run interface vlanif vlan-id

    The view of the VLANIF interface corresponding to the super-VLAN is displayed.

  3. Run arp-proxy inter-sub-vlan-proxy enable

    Proxy ARP is enabled between sub-VLANs.

Translation
Download
Updated: 2019-01-18

Document ID: EDOC1100038843

Views: 107398

Downloads: 71

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next