No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Ethernet Switching

S7700 and S9700 V200R012C00

This document describes the configuration of Ethernet services, including configuring MAC address table, link aggregation, VLANs, VLAN aggregation, MUX VLAN, VLAN termination, Voice VLAN, VLAN mapping, QinQ, GVRP, VCMP, STP/RSTP/MSTP, VBST, SEP, RRPP, ERPS, LBDT, HVRP, and Layer 2 protocol transparent transmission.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Setting the Aging Time of Dynamic MAC Address Entries

Setting the Aging Time of Dynamic MAC Address Entries

Context

Frequent topology changes result in the switch learning a large number of dynamic MAC addresses, some of which may no longer be in use. You can configure how long these entries remain in the MAC address table before the switch deletes them. A shorter aging time is suitable if the topology changes frequently, whereas a longer aging time is suitable if the topology remains stable.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run mac-address aging-time aging-time

    The aging time is set for dynamic MAC address entries.

    The aging time is 0 or an integer from 60 to 1000000, in seconds. The value 0 indicates that dynamic MAC address entries will not be aged out. The default value is 300.

    NOTE:

    If the aging time is set to 0, MAC address entries become fixed and never age out. To clear these entries, set the aging time to a non-0 value. The system then deletes these entries after twice the aging time.

Verifying the Configuration

Run the display mac-address aging-time command to view the aging time of dynamic MAC address entries.

Translation
Download
Updated: 2019-01-18

Document ID: EDOC1100038843

Views: 103018

Downloads: 69

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next