No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Ethernet Switching

S7700 and S9700 V200R012C00

This document describes the configuration of Ethernet services, including configuring MAC address table, link aggregation, VLANs, VLAN aggregation, MUX VLAN, VLAN termination, Voice VLAN, VLAN mapping, QinQ, GVRP, VCMP, STP/RSTP/MSTP, VBST, SEP, RRPP, ERPS, LBDT, HVRP, and Layer 2 protocol transparent transmission.
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring a Dot1q Termination Sub-interface

Configuring a Dot1q Termination Sub-interface

Context

When a VPN connects to an ISP network through a sub-interface, the sub-interface needs to remove a single VLAN tag from the packets sent to the ISP network. This can be achieved by configuring the sub-interface as a Dot1q termination sub-interface.

Procedure

  1. On the PE device, run system-view

    The system view is displayed.

  2. Run interface interface-type interface-number

    The interface view is displayed.

  3. Run port link-type { hybrid | trunk }

    The port link-type is set.

  4. Run quit

    Return to the system view.

  5. Run interface interface-type interface-number.subinterface-number

    The view of the sub-interface connecting the PE to the CE is displayed.

    NOTE:

    If the PW-side interface is a Layer 3 interface switched by the undo portswitch command, the AC-side interface cannot be a Layer 3 interface or subinterface belonging to a Layer 3 interface; otherwise, traffic forwarding is abnormal.

  6. Run dot1q termination vid low-pe-vid [ to high-pe-vid ]

    Dot1q termination is configured on the sub-interface.

    After a VLANIF interface is configured, the corresponding VLAN cannot be configured in a sub-interface view.

Translation
Download
Updated: 2019-01-18

Document ID: EDOC1100038843

Views: 94122

Downloads: 67

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next