No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Ethernet Switching

S7700 and S9700 V200R012C00

This document describes the configuration of Ethernet services, including configuring MAC address table, link aggregation, VLANs, VLAN aggregation, MUX VLAN, VLAN termination, Voice VLAN, VLAN mapping, QinQ, GVRP, VCMP, STP/RSTP/MSTP, VBST, SEP, RRPP, ERPS, LBDT, HVRP, and Layer 2 protocol transparent transmission.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Enabling the Voice VLAN Function

Enabling the Voice VLAN Function

Context

To implement the voice VLAN function, configure the VLAN used to forward voice packets on the switch as a voice VLAN and enable the voice VLAN. You are advised to configure different VLANs for voice and data services to facilitate management.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run interface interface-type interface-number

    The interface view is displayed.

  3. Run voice-vlan vlan-id enable [ include-untagged | include-tag0 ]*

    A voice VLAN is configured and the voice VLAN function is enabled on the interface.

    By default, the voice VLAN function is disabled on an interface.

    NOTE:
    • VLAN 1 cannot be configured as a voice VLAN.

    • To transmit different services, ensure that the voice VLAN and default VLAN on an interface are different VLANs.

    • Only one voice VLAN on an interface can be configured as a voice VLAN at a time.

    • After a voice VLAN is configured on an interface, VLAN mapping, VLAN stacking, or traffic policies cannot be configured on the interface.

    • When IP phones send packets tagged with VLAN 0, include-tag0 must be specified on interfaces of X series cards. On other models, include-untagged takes effect for untagged packets and packets tagged with VLAN 0.
    • If a VLAN is associated with a BD, it cannot be configured as a voice VLAN.

Translation
Download
Updated: 2019-01-18

Document ID: EDOC1100038843

Views: 118630

Downloads: 73

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next