No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Ethernet Switching

S7700 and S9700 V200R012C00

This document describes the configuration of Ethernet services, including configuring MAC address table, link aggregation, VLANs, VLAN aggregation, MUX VLAN, VLAN termination, Voice VLAN, VLAN mapping, QinQ, GVRP, VCMP, STP/RSTP/MSTP, VBST, SEP, RRPP, ERPS, LBDT, HVRP, and Layer 2 protocol transparent transmission.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
How Do I Add Member Interfaces to an Eth-Trunk?

How Do I Add Member Interfaces to an Eth-Trunk?

Before adding a new member interface, ensure that the type of the new member interface is the same as that of other member interfaces and there is no configuration on the new member interface.

  1. Run the shutdown command in the interface view to configure the new member interface in Down state.

    If the new member interface that joins the Eth-Trunk is not Down, a temporary loop may originate. As a result, services are affected.

  2. Run either of the following commands to add the new member interface to the Eth-Trunk.
    • Run the eth-trunk trunk-id command in the interface view.
    • Run the trunkport interface-type { interface-number1 [ to interface-number2 ] } &<1-8> command in the Eth-Trunk interface view.
  3. After member interfaces on two devices join the Eth-Trunk, run the undo shutdown command in the interface view to enable the new member interfaces.
Translation
Download
Updated: 2019-01-18

Document ID: EDOC1100038843

Views: 119094

Downloads: 73

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next