No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Ethernet Switching

S7700 and S9700 V200R012C00

This document describes the configuration of Ethernet services, including configuring MAC address table, link aggregation, VLANs, VLAN aggregation, MUX VLAN, VLAN termination, Voice VLAN, VLAN mapping, QinQ, GVRP, VCMP, STP/RSTP/MSTP, VBST, SEP, RRPP, ERPS, LBDT, HVRP, and Layer 2 protocol transparent transmission.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Setting the Link Aggregation Mode to Manual

Setting the Link Aggregation Mode to Manual

Context

Link aggregation can work in manual mode and LACP mode.

In manual mode, you must manually create an Eth-Trunk and add member interfaces to the Eth-Trunk. All active links forward data and evenly load balance traffic. The manual mode is used when the remote device does not support LACP.

If an Eth-Trunk interface has member interfaces, you can switch the Eth-Trunk interface's working mode between manual mode and LACP mode. However, if the Eth-Trunk interface is added to an E-Trunk, you cannot change its working mode.

To delete existing member interfaces, run the undo eth-trunk command in the interface view or the undo trunkport interface-type interface-number command in the Eth-Trunk interface view.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run interface eth-trunk trunk-id

    The Eth-Trunk interface view is displayed.

  3. Run mode manual load-balance

    The Eth-Trunk is configured to work in manual mode.

    By default, an Eth-Trunk works in manual mode.

    Before configuring an Eth-Trunk, ensure that both devices use the same working mode.

    NOTE:

    When configuring the Eth-Trunk on the EH1D2S24CEA0 card of the S9700, do not configure the Eth-Trunk to work in manual mode.

Translation
Download
Updated: 2019-01-18

Document ID: EDOC1100038843

Views: 96021

Downloads: 67

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next