No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Configuration Guide - Ethernet Switching

S7700 and S9700 V200R012C00

This document describes the configuration of Ethernet services, including configuring MAC address table, link aggregation, VLANs, VLAN aggregation, MUX VLAN, VLAN termination, Voice VLAN, VLAN mapping, QinQ, GVRP, VCMP, STP/RSTP/MSTP, VBST, SEP, RRPP, ERPS, LBDT, HVRP, and Layer 2 protocol transparent transmission.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring RRPP Snooping

Configuring RRPP Snooping


RRPP snooping is a technology that notifies the VPLS network of changes in the RRPP ring. After RRPP snooping is enabled on sub-interfaces or VLANIF interfaces, the VPLS network can transparently transmit RRPP packets, detect changes on the RRPP ring, and upgrade forwarding entries, ensuring that traffic can be rapidly switched to a non-blocking path. Before configuring RRPP snooping, complete the following tasks:
  • Configure a VPLS network.
  • Configure RRPP.
Updated: 2019-01-18

Document ID: EDOC1100038843

Views: 109269

Downloads: 72

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next