No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Ethernet Switching

S7700 and S9700 V200R012C00

This document describes the configuration of Ethernet services, including configuring MAC address table, link aggregation, VLANs, VLAN aggregation, MUX VLAN, VLAN termination, Voice VLAN, VLAN mapping, QinQ, GVRP, VCMP, STP/RSTP/MSTP, VBST, SEP, RRPP, ERPS, LBDT, HVRP, and Layer 2 protocol transparent transmission.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring SEP

Configuring SEP

When there is no faulty link on a ring network running SEP, SEP can eliminate loops on the Ethernet. When a link fault occurs on the ring network, SEP can immediately restore the communication between the nodes on the network.

Pre-configuration Tasks

Before configuring basic SEP functions, complete the following tasks:

  • Establish the ring network.

  • Ensure that the devices are powered on correctly and operate properly.

Translation
Download
Updated: 2019-01-18

Document ID: EDOC1100038843

Views: 95437

Downloads: 67

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next