No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Ethernet Switching

S7700 and S9700 V200R012C00

This document describes the configuration of Ethernet services, including configuring MAC address table, link aggregation, VLANs, VLAN aggregation, MUX VLAN, VLAN termination, Voice VLAN, VLAN mapping, QinQ, GVRP, VCMP, STP/RSTP/MSTP, VBST, SEP, RRPP, ERPS, LBDT, HVRP, and Layer 2 protocol transparent transmission.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
(Optional) Configuring the Root Bridge and Secondary Root Bridge

(Optional) Configuring the Root Bridge and Secondary Root Bridge

Context

MSTP can calculate the root bridge or you can manually configure the root bridge or secondary root bridge. Manually configuring the root bridge and secondary root bridge is recommended.

A switch can function as a root bridge or a secondary root bridge in a spanning tree. It can also function as the root bridge or secondary root bridge of another spanning tree. In a spanning tree:

  • Only one root bridge takes effect. If two or more root bridges are specified in a spanning tree, the device with the smallest MAC address is used.
  • Multiple secondary root bridges can be specified. If the root bridge fails or is powered off and no new root bridge is specified, the secondary root bridge with smallest MAC address will become the root bridge of the spanning tree.

Procedure

  • Perform the following operations on the device to be used as the root bridge.
    1. Run system-view

      The system view is displayed.

    2. Run stp process process-id

      The MSTP process view is displayed.

    3. Run stp [ instance instance-id ] root primary

      The device is configured as the root bridge.

      By default, a switch does not function as the root bridge. After the configuration is complete, the priority value of the device is 0 (this value cannot be modified).

      If instance is not specified, the device in MSTI 0 is a root bridge.

  • Perform the following operations on the device to be used as the secondary root bridge.
    1. Run system-view

      The system view is displayed.

    2. Run stp process process-id

      The MSTP process view is displayed.

    3. Run stp [ instance instance-id ] root secondary

      The device is configured as the secondary root bridge.

      By default, a switch does not function as the secondary root bridge. After the configuration is complete, the priority value of the device is 4096 (this value cannot be modified).

      If instance is not specified, the device in MSTI 0 is a secondary root bridge.

Translation
Download
Updated: 2019-01-18

Document ID: EDOC1100038843

Views: 94911

Downloads: 67

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next