No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Ethernet Switching

S7700 and S9700 V200R012C00

This document describes the configuration of Ethernet services, including configuring MAC address table, link aggregation, VLANs, VLAN aggregation, MUX VLAN, VLAN termination, Voice VLAN, VLAN mapping, QinQ, GVRP, VCMP, STP/RSTP/MSTP, VBST, SEP, RRPP, ERPS, LBDT, HVRP, and Layer 2 protocol transparent transmission.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Manually Switching to the VBST Mode

Manually Switching to the VBST Mode

Context

When a port on a VBST-enabled switch is connected to an STP-enabled switch, the port automatically switches to the STP mode.

In the following cases, you need to switch the port back to the VBST mode manually:

  • The STP-enabled switch is shut down or disconnected.

  • The STP-enabled switch is switched to the RSTP/MSTP mode.

When a VBST-enabled switch connects to an MSTP-enabled switch, the connected port of the MSTP-enabled switch automatically switches to the RSTP mode through negotiation. When the VBST-enabled switch switches to the MSTP mode, the connected ports of the two switches may still work in RSTP mode due to the time sequence problem. You can perform the following operations to manually switch the ports to the MSTP mode.

Procedure

  • Switching a port to the VBST mode
    1. Run system-view

      The system view is displayed.

    2. Run interface interface-type interface-number

      The view of the interface that participates in spanning tree calculation is displayed.

    3. Run stp mcheck

      The port is switched to the VBST mode.

  • Switching the switch to the VBST mode
    1. Run system-view

      The system view is displayed.

    2. Run stp mcheck

      The switch is switched to the VBST mode.

      After the switch is switched to the VBST mode in the system view, all ports switch to the VBST mode.

Translation
Download
Updated: 2019-01-18

Document ID: EDOC1100038843

Views: 95555

Downloads: 67

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next