No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Ethernet Switching

S7700 and S9700 V200R012C00

This document describes the configuration of Ethernet services, including configuring MAC address table, link aggregation, VLANs, VLAN aggregation, MUX VLAN, VLAN termination, Voice VLAN, VLAN mapping, QinQ, GVRP, VCMP, STP/RSTP/MSTP, VBST, SEP, RRPP, ERPS, LBDT, HVRP, and Layer 2 protocol transparent transmission.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Application of the RRPP Multi-instance Ring and Smart Link Network

Application of the RRPP Multi-instance Ring and Smart Link Network

In Figure 18-28, CEs are dual-homed to UPEs through Smart Link technology.

Figure 18-28  RRPP multi-instance ring and Smart Link network

Four UPEs and one PE-AGG construct a ring. After RRPP multi-instance on the ring is enabled, traffic flows into the backbone network through the PE-AGG.

Nodes on the RRPP ring and the PE-AGG must support Smart Link.

Translation
Download
Updated: 2019-01-18

Document ID: EDOC1100038843

Views: 95053

Downloads: 67

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next