No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Configuration Guide - Ethernet Switching

S7700 and S9700 V200R012C00

This document describes the configuration of Ethernet services, including configuring MAC address table, link aggregation, VLANs, VLAN aggregation, MUX VLAN, VLAN termination, Voice VLAN, VLAN mapping, QinQ, GVRP, VCMP, STP/RSTP/MSTP, VBST, SEP, RRPP, ERPS, LBDT, HVRP, and Layer 2 protocol transparent transmission.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Application of RRPP and STP

Application of RRPP and STP

RRPP cannot be configured with STP/RSTP/MSTP on the same interface at the same time, but you can configure RRPP and STP on different interfaces of a device. Figure 18-23 shows an example of a network that has RRPP and STP configured on different interfaces of the same device.

Figure 18-23  Network of RRPP and STP

In Figure 18-23, RRPP is applied to an Ethernet network enabled with STP/RSTP/MSTP in tangent mode. You can enable RRPP and STP/RSTP/MSTP on different interfaces of the intersecting device (UPE1) so that the RRPP network and the STP/RSTP/MSTP network are used together.

Updated: 2019-01-18

Document ID: EDOC1100038843

Views: 108680

Downloads: 72

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next